Sunday, December 1, 2013

Amp Hour Meter for Wind Generator

My only "almost finished" micro project!
(Quit working on it Nov 2013)

To prove to myself that the wind generator was not a total waste of money, I decided I needed a way to track the electricity it made.

It is a ATMEGA328 with ardunio UNO bootloader copied from the "serial LCD backpack" tutorial which I can no longer find on their site. It is connected to the ACS-714 30 amp current sensor I made and posted about a while back.

On the left side, the time rolls over each 24 hours, and resets the total amp hours (Ah=). The right side shows the instantaneous amps (A- discharging-no wind) and the cycles available for more calculation each period (debugging, I said almost finished).

Within 2 weeks of "almost finishing" the bearings went out in the wind generator. I had been seeing less that 20 amp hours per day most days, so I haven't been that excited about climbing the mast a couple times to get it down, repair it and put it back up. And in the mean time I have upped the solar panels to 600 watts, which has taken care of the 120 amp hour/day load we have (before noon most days).

Mounted below companion way.

The board, 5v on right, sensor on left, FTDI Friend programming header upper right
The ACS714-30amp that I post about before

I followed SparkFun's schematic fairly well. My display had the 16 pin connector reversed, so that took a little changing.

Tuesday, August 20, 2013

Eldon and ASC712 Current PCB

While visiting Seattle, Eldon and I made a new version of the high current monitor pcb.
Eldon demonstrating his stage microscope for SMD parts.
We used the laserjet and toner transfer method. Then etched in a zip-lock baggie of the nasty stuff under running warm water from the sink.
The new version of the ASC712-150 board

Thursday, March 7, 2013

A Serial Backpack for 1602 LCD

I tried to make a serial accessed backpack for a 1602 LCD display suitable for the ardunio.

This one with an unlatched shift register.